Таблица | Карточка | RUSMARC | |
Разрешенные действия: Прочитать Загрузить (2,3 Мб) Группа: Анонимные пользователи Сеть: Интернет |
Аннотация
The distribution of the wind flow has been studied and its effect on the stressed state of the shell of a steel vertical cylindrical tank. Variants of wind pressure were considered for one tank and for a group of tanks. Aerodynamic coefficients are obtained for the considered variants in the SolidWorks software package. A physical experiment on a reduced tank model in a wind tunnel was conducted to verify the coefficients obtained. The stresses in the tank shell were determined by the finite element method using the SCADOffice calculation complex. The result revealed differences normative distribution of wind pressure from the pilot for single tank and located in the band. The most unfavorable version of the distribution of wind pressure for the tank located in the group was determined. The stress-strain state of the tank shell is compared under the normative and experimental wind load for the most unfavorable variant.
Изучено распределение ветрового потока и его влияние на напряженное состояние стенки стального вертикального цилиндрического резервуара. Рассматривались варианты ветрового давления на один резервуар и на группу резервуаров. Аэродинамические коэффициенты для рассматриваемых вариантов получены в программном комплексе SolidWorks. Для верификации полученных коэффициентов был проведён физический эксперимент на уменьшенной модели резервуара в аэродинамической трубе. Напряжения в стенке резервуара определялись методом конечных элементов при помощи расчётного комплекса SCADOffice. В результате выявлены отличия нормативного распределения ветрового давления от экспериментального для одиночного резервуара и находящегося в группе. Определён наиболее неблагоприятный вариант распределения ветрового давления для резервуара, находящегося в группе. Проведено сравнение напряженно-деформированного состояния стенки резервуара при нормативной и экспериментальной ветровой нагрузке для наиболее невыгодного варианта.
Права на использование объекта хранения
Оглавление
- The stress state of a tank shell in the group under wind load
- Напряжения от ветровой нагрузки в стенке резервуара, находящегося в группе
- 1. Introduction
- 2. Methods
- 3. Results and Discussion
- 3.1. Statement of a Problem of Numerical Experiment:
- 3.2. The Size of the Computational Domain
- 3.3. The Choice of Boundary and Initial Conditions
- 3.4. Simulation of Finite Elements Model of a Tank in SCAD Office
- 3.5. Parameters of a Tank FE Model
- 3.6. Determining the Design Load Based on the Results of Numerical Simulation
- 3.7. Specifying the Load by Means of a Text File
- 3.8. Finite Element Analysis of the Shell Strain-Stress State at the Wind Load on Isolated Vertical Cylindrical Tank According to Eurocodes and Numerical Simulation Results
- 3.9. Finite Element Analysis of Strain-Stress State of the Shell at Unfavorable Wind Load on VCT, Consisting of a Group of 4 Objects
- 3.10. Discussion
- 4. Conclusion
Входит в состав
Статистика использования
Количество обращений: 287
За последние 30 дней: 20 Подробная статистика |