Детальная информация

Название: Effect of vertical circular openings on flexural strength of reinforced concrete beam // Magazine of Civil Engineering. – 2021. – № 6 (106). — С. 10601
Авторы: Auta S. M.; Jamiu O.; Alhaji B.
Выходные сведения: 2021
Коллекция: Общая коллекция
Тематика: Строительство; Строительная механика; reinforced concrete beams; beams with holes; beam bends; beam strength; vertical round holes; computer simulation; железобетонные балки; балки с отверстиями; изгибы балок; прочность балок; вертикальные круглые отверстия; компьютерное моделирование
УДК: 624.04
ББК: 38.112
Тип документа: Статья, доклад
Тип файла: PDF
Язык: Английский
DOI: 10.34910/MCE.106.1
Права доступа: Свободный доступ из сети Интернет (чтение, печать, копирование)
Ключ записи: 0d00d3e0-26a2-4bcc-a496-2823476b0e7e

Разрешенные действия: Прочитать Загрузить (314 Кб)

Группа: Анонимные пользователи

Сеть: Интернет

Аннотация

Modern building construction techniques sometimes involve the passing of pipes or ducts for water supply, electrification, and telecommunication through reinforced concrete beams to protect them against mechanical damages and add aesthetic value to buildings. This study looks into the effect of vertical circular openings on the flexural strength of the reinforced concrete beam. Two (2) sets of beam samples were investigated during this study: computer simulated reinforced concrete (RC) beam using ANSYS 19.1 and laboratory cast. The results of the flexural strength test conducted show the following: Reinforced concrete beam with vertical circular openings of diameter greater than 33.3 % of beam width (B) reduced its flexural strength by at least 20 %; maximum compressive stress of concrete occurs at the openings region of the beam; the difference in ultimate load capacity of finite element (FE) beam models and experimental beam specimen is 3.5 %. It can be deduced that ANSYS software is an appropriate finite element (FE) tool to predict the behaviour of RC beams. Hence, it is hereby recommended that the diameter of the vertical circular opening in RC beam should not exceed 33.3 % of the beam width and its location from beam support should not exceed L/6.

Права на использование объекта хранения

Место доступа Группа пользователей Действие
Локальная сеть ИБК СПбПУ Все Прочитать Печать Загрузить
-> Интернет Все Прочитать Печать Загрузить

Оглавление

  • Effect of vertical circular openings on flexural strength of reinforced concrete beam
    • 1. Introduction
    • 2. Materials and Method
      • 2.1. Description of specimen
      • 2.2. Laboratory investigation
      • 2.3. Computer modeled beam specimen
    • 3. Results and Discussion
      • 3.1. Flexural strength
      • 3.2. Stresses at Ultimate Load for ANSYS Beam Specimens
      • 3.3. Comparison of Results with Reviewed Literatures
    • 4. Conclusion and Recommendations

Статистика использования

stat Количество обращений: 145
За последние 30 дней: 12
Подробная статистика