Table | Card | RUSMARC | |
Allowed Actions: –
Action 'Read' will be available if you login or access site from another network
Group: Anonymous Network: Internet |
Annotation
В данной выпускной квалификационной работе бакалавра была поставлена задача создать параметрический обратный направляющий аппарат. Также было необходимо сравнить исходный ОНА с ОНА с спроектированным по методике НЗЛ и вариант с измененными параметрами. Была построена трёхзвенная ступень в модуле Ansys – DesignModeler. Для расчёта ступени и получения газодинамических характеристик была исполь-зована система инженерного анализа – Ansys, а конкретно следующие моду-ли этой системы: TurboGrid для настройки и создания сетки, CFX-Solver для решения поставленной инженерной задачи и её обработки. После обработки всех расчётов, были получены коэффициенты потери для всех трёх вариантов. Лучшим из них оказался исходный ОНА. Причиной тому послужила неудовлетворительная сходимость, а также потому что осо-бенностью методики НЗЛ является ОНА с относительно высоким коэффици-ентом потерь. Рекомендуется применять для оптимизации ОНА другую методику проекти-рования, а также применять более высокомощные ЭВМ для обеспечения нужной точности расчёта.
In this final qualifying work of the bachelor, the task was to create a parametric return channel. It was also necessary to compare the original RC with the RC de-signed by the NZL method and the variant with changed parameters. A parametric stage was built in the Ansys - DesignModeler module. To calculate the stage and obtain gas-dynamic characteristics, the engineering analysis system - Ansys was used, and specifically the following modules of this system: Tur-boGrid for setting up and creating a mesh, CFX-Solver for solving the engineer-ing problem and its processing. After processing all the calculations, the loss coefficients were obtained for all three options. The best of them turned out to be the original RC. The reason for this was the unsatisfactory convergence, as well as because a feature of the NZL technique is RC with a relatively high loss factor. It is recommended to use a different design technique to optimize the RC, as well as to use higher-power computers to ensure the required calculation accuracy.
Document access rights
Network | User group | Action | ||||
---|---|---|---|---|---|---|
ILC SPbPU Local Network | All | |||||
Internet | Authorized users SPbPU | |||||
Internet | Anonymous |
Usage statistics
Access count: 9
Last 30 days: 1 Detailed usage statistics |