Table | Card | RUSMARC | |
Allowed Actions: –
Action 'Read' will be available if you login or access site from another network
Group: Anonymous Network: Internet |
Annotation
Тема выпускной квалификационной работы: «Проектирование центробежного компрессора станции магистрального газопровода Pнач=5,17 МПа, П=1,44, Т=293 К». Данная работа посвящена проектированию компримирующего природный газ центробежного компрессора по заданным параметрам с газотурбинным приводом, предназначенного для эксплуатации на линейной компрессорной станции магистрального газопровода. В ходе работы были проведены предварительные вариантные расчёты, окончательный термогазодинамический расчёт проточной части центробежного компрессора выбранного варианта, конструктивные и прочностные расчёты. Для расчёта за основу была взята методика НЗЛ и методы, производные от метода НЗЛ. По этому методу принимается, что процесс преобразования энергии в элементах проточной части происходит с постоянным для всей ступени политропным коэффициентом полезного действия. В результате расчёта был спроектирован одновальный двухступенчатый компрессор без промежуточного охлаждения с радиальными рабочими колёсами и лопаточным диффузором. Были рассчитаны размеры разгрузочного поршня (думмиса), профили лопаток рабочих колёс, диффузоров, обратно-направляющих аппаратов.
The subject of the graduate qualification work is "Designing a centrifugal compressor for a main gas pipeline station Pin=5,17 MPa, π=1,44, T=293 K". The given work is devoted to the design of a natural gas compressing centrifugal compressor according to the given parameters with a gas turbine drive, intended for operation at a linear compressor station of a main gas pipeline. In the course of the work, preliminary variant calculations, the final thermogasdynamic calculation of the flow path of the centrifugal compressor of the selected variant, structural and strength calculations were carried out. The calculation was based on the Nevsky Zavod method and methods derived from the Nevsky Zavod method. According to this method, it is assumed that the process of energy conversion in the elements of the flow path occurs with a polytropic efficiency constant for the entire stage. As a result of the calculation, a single-shaft two-stage compressor without intermediate cooling with radial impellers and a blade diffuser was designed. The dimensions of the balance piston, the profiles of the impeller blades, diffusers, and return-guide vanes were calculated.
Document access rights
Network | User group | Action | ||||
---|---|---|---|---|---|---|
ILC SPbPU Local Network | All | |||||
Internet | Authorized users SPbPU | |||||
Internet | Anonymous |
Usage statistics
Access count: 11
Last 30 days: 0 Detailed usage statistics |