Детальная информация

Название Simplified finite element model for rectangular CFST columns strength calculation under eccentric compression // Magazine of Civil Engineering. – 2025. – Т. 18, № 2. — С. 13406
Авторы Chepurnenko A. ; Yazyev B. ; Al-Zgul S. ; Tyurin V.
Выходные сведения 2025
Коллекция Общая коллекция
Тематика Строительство ; Строительная механика ; rectangular columns ; column strength calculation ; finite element models ; eccentric compression ; numerical simulation ; reinforced concrete structures ; прямоугольные колонны ; расчет прочности колонн ; конечно-элементные модели ; эксцентрическое сжатие ; численное моделирование ; железобетонные конструкции
УДК 624.04
ББК 38.112
Тип документа Статья, доклад
Язык Английский
DOI 10.34910/MCE.134.6
Права доступа Свободный доступ из сети Интернет (чтение, печать, копирование)
Дополнительно Новинка
Ключ записи RU\SPSTU\edoc\78145
Дата создания записи 27.01.2026

Разрешенные действия

Прочитать Загрузить (1,5 Мб)

Группа Анонимные пользователи
Сеть Интернет

Concrete filled steel tubular (CFST) column is one of the most effective building structures types that combine high bearing capacity and economy. Three-dimensional nonlinear finite element analysis is the most common and reliable method for determining the bearing capacity of CFST columns. This approach is usually applied to individual elements and is not suitable for calculating buildings and structures with CFST elements as a single whole, due to high computational complexity. The purpose of the article is to develop a simplified model that allows reducing a three-dimensional problem of calculating a CFST column to a two-dimensional one. Rectangular CFST columns subjected to eccentric compression with eccentricity in two planes are considered. The problem dimension is reduced based on the hypothesis of plane sections. Rectangular elements are used for the concrete core and one-dimensional bar elements are used for the steel pipe. The developed model was verified by comparing calculation results with the results of three-dimensional finite element modeling in ANSYS. The maximum discrepancy between the results for stresses was 2.3%. The model was also validated on experimental data for 38 samples presented in 3 different papers. The proposed model allows to significantly reduce the machine time costs when calculating CFST columns in a physically nonlinear formulation.

Место доступа Группа пользователей Действие
Локальная сеть ИБК СПбПУ Все
Прочитать Печать Загрузить
Интернет Все
  • Simplified finite element model for rectangular CFST columns strength calculation under eccentric compression
    • 1. Introduction
    • 2. Methods
    • 3. Results and Discussion
    • 4. Conclusions

Количество обращений: 25 
За последние 30 дней: 25

Подробная статистика