Table | Card | RUSMARC | |
Allowed Actions: –
Action 'Read' will be available if you login or access site from another network
Group: Anonymous Network: Internet |
Annotation
Тема выпускной квалификационной работы: «Проектирование подводного буксировщика. Конструкторская проработка и расчёт элементов проточной части». Данная работа посвящена разработке проекта подводного тягача. Подводный тягач – агрегат для перемещения человека под и над поверхностью воды, может быть использован в развлекательных, рабочих или военных целях в зависимости от требований покупателя. В процессе работы был проведен анализ аналогичных агрегатов, выявлены общие параметры. Так же был выполнен гидродинамический расчёт гребного винта, его параметризация и оптимизация. После получения оптимизированной геометрии были выполнены проверочные расчёты, а после – сравнение и анализ всех полученных данных. После проведения расчётов была создана трёхмерная сборка, на её основе была создана конструкторская документация, включающая в себя сборочные чертежи, спецификацию и деталировочные чертежи. Была определена плавучесть агрегата. Все проделанные расчёты были завершены успешно и дали положительные результаты. На основе проделанной работы можно начать производство подводных тягачей, которые в состоянии составить конкуренцию аналогичным агрегатам на рынке.
The subject of the graduate of qualification work is «Design of an underwater tow truck. Design study and calculation of flow elements». This work is devoted to the development of the underwater tractor project. Underwater tractor-unit for moving people under and above the surface of the water, can be used for entertainment, work or military purposes, depending on the requirements of the buyer. In the course of work, an analysis of similar aggregates was carried out, and common parameters were identified. The hydrodynamic calculation of the propeller, its parameterization and optimization were also performed. After obtaining the optimized geometry, verification calculations were performed, and then all the data obtained was compared and analyzed. After the calculations, a three-dimensional Assembly was created, and design documentation was created based on it, including Assembly drawings, specifications, and detailed drawings. The buoyancy of the unit was determined. All the calculations were completed successfully and gave positive results. Based on the work done, it is possible to start production of underwater tractors that can compete with similar units on the market.
Document access rights
Network | User group | Action | ||||
---|---|---|---|---|---|---|
ILC SPbPU Local Network | All |
![]() |
||||
External organizations N2 | All |
![]() |
||||
External organizations N1 | All | |||||
Internet | Authorized users SPbPU |
![]() |
||||
Internet | Authorized users (not from SPbPU, N2) |
![]() |
||||
Internet | Authorized users (not from SPbPU, N1) | |||||
![]() |
Internet | Anonymous |
Usage statistics
|
Access count: 1
Last 30 days: 0 Detailed usage statistics |