Table | Card | RUSMARC | |
Allowed Actions: –
Action 'Read' will be available if you login or access site from another network
Action 'Download' will be available if you login or access site from another network
Group: Anonymous Network: Internet |
Annotation
Тема выпускной квалификационной работы: «Калибровка и исследование неопределенности измерений на экзаменаторе М-055». Данная работа посвящена исследованию неопределенности измерений путем калибровки экзаменатора М-055. Измерительный прибор разработан в ИМЦ «Микро», основанным на базе «Высшей школы машиностроения». Задачи, которые решались в ходе исследовательской работы: 1. Изучение явления неопределенности измерения 2. Проведение эксперимента по выявлению действительной погрешности экзаменатора М-055 3. Определение годности экзаменатора М-055 Для решения поставленных задач на базе «Высшей школы машиностроения» СПбПУ была собрана исследовательская установка и был произведен эксперимент, позволяющий дать заключение о пригодности экзаменатора М-055. В третьей части выпускной работы были определены основные технологические задачи при изготовлении детали «Корпус» в сборочной единице «Механизм микроподачи». Спроектирован технологический процесс изготовления детали «Корпус». Сформирован комплект технологической документации. Спроектировано установочно-зажимное приспособление для выбранной операции.
The subject of the graduate qualification work is “Calibration and error of measurement research on examinator M-055”This work is devoted to the study of the measurement uncertainty by the calibration method of the M-055 examiner.The measuring device wasdeveloped at the IMC "Micro", based on the basis of the "Higher School of Mechanical Engineering". The tasks that were solved during the research work:1.Studyof measurement uncertainty2.Conducting an experiment to identify the actual error of the examiner M-0553.Determination of the suitability of the examiner M-055To solve the set tasks, a research installation was assembled on the basis of the Higher School of Mechanical Engineering of SPbPU, and an experiment was carried out, allowing to give a conclusion about the suitability of the M-055 examiner.In the third part of the work, the main technological tasks were identified in the manufacture of the "Corps" part in the assembly unit "Micro-feed mechanism". The technological process forthe manufacture ofthe "Corps" part has been designed. A set of technological documentation has been formed. The setting jig has been designed for the selected operation.
Document access rights
Network | User group | Action | ||||
---|---|---|---|---|---|---|
ILC SPbPU Local Network | All | |||||
Internet | Authorized users SPbPU | |||||
Internet | Anonymous |
Usage statistics
Access count: 20
Last 30 days: 0 Detailed usage statistics |