Table | Card | RUSMARC | |
Allowed Actions: –
Action 'Read' will be available if you login or access site from another network
Group: Anonymous Network: Internet |
Annotation
Данная работа содержит расчёт установившихся режимов системы, выбор оборудования, расчёт токов при несимметричном коротком замыкании и анализ динамических свойств системы. Решаемые задачи: 1. Выбор оборудования для заданной энергосистемы: генераторов, трансформаторов, линий электропередачи, автотрансформаторов. 2. Расчет и анализ установившегося режима в энергосистеме в программе RastrWin. 3. Моделирование несимметричного короткого замыкания в энергосистеме и разработка мер по снижению токов короткого замыкания в программе «EMTP». 4. Моделирование комплекса предприятий по повышению динамической устойчивости заданной энергосистемы в программе «Dymola». В ходе написания работы было выбрано соответствующее оборудование. Расчет установившегося режима показал, что для уменьшения падения напряжения в узлах нагрузки необходимо установить средства компенсации. Далее было смоделировано и рассчитано однофазное короткое замыкание и были предложены меры по снижению токов до уровня трехфазного короткого замыкания. При анализе динамических свойств системы было выявлено, что заданная энергосистема обладает динамической устойчивостью при однофазном коротком замыкании, поэтому были выбраны более тяжелые условия аварии. Далее был предложен комплекс мероприятий по повышению динамической устойчивости системы.
This work is devoted to the calculation of the steady state modes of the system, the choice of equipment, the calculation of currents in case of an asymmetric short circuit and the calculation of the transient properties of the system. Tasks to be solved: 1. Selection of equipment for a given power system: generators, transformers, power lines, autotransformers. 2. Calculation and analysis of the steady state in the power system in program RastrWin. 3. Simulation of an asymmetric short circuit in the power system and development of measures to reduce short circuit currents in program «EMTP». 4. Modeling the enterprise complex to improve the transient stability of a given power system in program «Dymola». In the course of writing the work, the equipment corresponding to the given power system was selected. The calculation of the steady state showed that in order to reduce the voltage drop in the load nodes, it is necessary to install compensation means. Next, a single-phase short circuit was modeled and calculated, and measures were proposed to reduce currents to the level of a three-phase short circuit. When analyzing the transient properties of the system, it was found that the given power system has good transient stability in the event of a single-phase short circuit, so more severe accident conditions were chosen. Further, a set of measures was proposed to improve the transient stability of the system.
Document access rights
Network | User group | Action | ||||
---|---|---|---|---|---|---|
ILC SPbPU Local Network | All | |||||
Internet | Authorized users SPbPU | |||||
Internet | Anonymous |
Usage statistics
Access count: 14
Last 30 days: 9 Detailed usage statistics |